Epoxy & Coating Removal

Commercial Epoxy & Coating Removal in Sydney

Resin Me Epoxy mechanically removes failed epoxy, polyurethane, paint and other bonded floor coatings from commercial and industrial concrete. We work in warehouses, factories, retail spaces, workshops and construction sites where the slab must be prepared for a specified new flooring system.

The existing coating is inspected for thickness, hardness, adhesion and contamination before tooling is selected. Aggressive PCD tooling may be used for thick or flexible coatings, followed by diamond grinding to refine the surface. Thin or brittle systems may require a different sequence; there is no single tooling setup for every slab.

Commercial grinders are connected to H-Class dust extraction and edges are detailed with suitable hand equipment. This controls airborne dust but does not make the process completely dust-free. Access, noise restrictions, power availability, nearby trades and the required surface profile are confirmed before work starts.

Removal can reveal cracks, repairs, weak concrete, staining or previous substrate damage. We do not promise that every mark will disappear or that grinding will produce a perfectly level slab. Newly exposed defects are reported so repairs or further preparation can be agreed before the next system is installed.

For an accurate quote, provide the floor area, coating type if known, site photos, access details, available power, programme and the next flooring specification. For broader preparation after removal, see our concrete floor preparation service. If new epoxy installation is also required, see our commercial epoxy flooring service.

What commercial clients can expect

• Tooling selected after a site and coating assessment
• PCD and diamond-grinding options for different systems
• Remote-control and three-phase equipment where access allows
• H-Class dust extraction and detailed edge preparation
• Clear scope for coating removal and final surface profile
• Access, power, noise and programme requirements confirmed
• Suitable for warehouses, factories, retail and construction sites
• Exposed cracks and weak concrete reported, not concealed
• Final vacuuming and inspection before handover
• Quote based on actual floor condition and intended next system

Coating removal before the next flooring system

We assess commercial coating-removal and preparation packages individually, including open warehouse and factory floors. Builders and flooring contractors can engage us for the preparation scope and arrange the replacement flooring separately. Send the existing coating details, approximate area, photos and next flooring specification for assessment.

What condition is the slab handed over in?

The quotation should identify the coating to be removed, required surface profile, accessible edges, cleaning and any separately agreed repairs. Share the new flooring specification before removal starts. Grinding can expose defects or contamination that require further assessment before the next contractor installs their system.

Can work be staged around warehouse operations?

Tell us which areas can be cleared, the available working hours and when each area needs to be handed over. Access, power, dust controls and protection of neighbouring areas are reviewed before the programme is confirmed. Send your coating-removal scope and plans.